The ExDetector HC 100 is used to measure the current concentration of explosive gases and vapors.

With the ExDetector HC 100 combustible gases and vapors are detected in the measuring range from 0 to 100 % LEL. The measuring principle is based on catalytic combustion (heat tinting). With this measuring principle a large number of gases e.g. hydrogen and hydrocarbons can be monitored.

The ExDetector HC 100 is a particularly versatile sensor and can be used in particular
in Ex zone 1 and in overall safety systems classified according to SIL-1.

A type examination certificate for the measuring function according to
BAM 03 ATEX 0003 X is available.

Variant: ExDetector HC 100 K

The probe combination ExDetector HC 100-T and HC 100-K has been specially developed for duct installation and has a remote transmitter.

This special combination is used to measure the current concentration of explosive gases and vapors in a duct network.

• EC type examination according to
  RL 2014/34/EU,
  Electrical safety of the equipment:
  II 2G
  Ex de [ib] IIC T6
  PTB 00 ATEX 1075
• EC type examination according to
  RL 2014/34/EU,
  measuring function:
  BAM 03 ATEX 0003 X
• detectable gases:
  explosive gases and vapors

• Measuring range 0 – 100 % LEL
  (lower explosion limit)
• Measuring principle catalytic combustion (heat tinting)
• linear measuring signal 4 – 20 mA
• one-man calibration – direct
  adjustment at the detector
  (optional operating device)
• 3-wire technology